How To Clean Carbs On A Snowmobile

• Remove the side panel.

• Pull the 2 safety straps off.

• Pull the panel up and out.

• Remove the belt cover by removing the pin.

• Utilize the secondary tool to expand the clutch. Turn clockwise.

• After this is washed, roll the belt over the clutch to remove belt. Rolling the belt towards the dorsum end of the machine.

• Remove the bolt on secondary clutch with a 1/2"(12.vii mm) open concluded box wrench.

• Pull the commodities and washers out.

• Slide the secondary clutch off of the shaft.

• Using a 3/8"(nine.525 mm) socket on the 3/8" ratchet, remove the air horn bolts, and pull the air horn out.

• Pull the rubber strap off of the air box.

• Remove the airbox by pulling the box up and out towards yourself.

• Circumspection: Exist careful of pulling wires and cables.

• Turn the fuel off past turning the red fuel knob to the off position so that information technology is perpendicular to the hose.

• Annotation: direct piece on knob that is in line with hose ways open. Perpendicular to the fuel hose means it is closed. (i.e. picture 2)

• Using a flat head spiral driver, loosen the hose clamps on the carburetor boots so that it can be removed after.

• Using a 10 mm open ended box wrench, loosen the height and bottom nuts on the asphyxiate and throttle cable that are fastened to the carburetor.

• Pull the carburetor off and so that information technology can be rotated to the side.

• Pull the choke and throttle cables off by sliding cable through slots.

• Using a needle olfactory organ pliers, remove the hose clamp from the fuel hose that leads to the fuel rail.

• Pull the fuel line off of the fuel rail connector. Be conscientious to not break the hose and/or connector.

• Set a rag underneath the carb and fuel line to catch the fuel that pours out.

• Set up the carb rack on paper towels in case fuel leaks out.

• On bottom side, have a 11/16" socket on a three/8" ratchet to remove the bowls.

• Remove the master jet with a i/4" deep socket on a i/four" ratchet.

• Using a #2 Phillips head screw driver, remove the screw property the bottom cover on.

• Exist cautious of the gasket falling out of slot on the cover.

• Use the carburetor cleaner to spray the floats and pilot air jet.

• Remove the 4 screws using a #2 Phillips screw driver that connect the top plate to carbs.

• Caution: the gasket tin be removed with elevation comprehend plate.

• Spray the carb cleaner on the summit part of the carb. Ensure clean mechanical action of needle guide.

• Spray carb cleaner on the bowls.

Source: https://www.ifixit.com/Guide/How+to+Clean+Mikuni+Snowmobile+Carburetor/98168

Posted by: alvarezupway1945.blogspot.com

Share this post